Safety of machinery. Safety requirements for pressure metal diecasting units Ingestion-build-89079 This document specifies a procedure

This document specifies a procedure for the evaluation of the filterability of lubricating oils

What is BS 2782-6:Methods 620A to 620D – Testing density and relative density of non-cellular plastics about

BS EN 61675-2 on gamma cameras for planar

intended for outdoor and/or indoor use by one person at a time

This European Standard may also be used for piping greater than DN 40 and/or vessels greater than 2 l

Safety of machinery. Safety requirements for pressure metal diecasting units Ingestion-build-89079 This document specifies a procedure1 Scope This European Standard specifies the safety requirements for pressure metaldiecasting units. It applies to pressure diecasting machines and to the interfaces with the following ancillary equipment: die, melting, holding and dosing furnaces (see EN 7461), metal feeding equipment, inserting and removal devices, spraying appliances, heat exchanger for the die. This ancillary equipment itself is not covered. Additional risks arising from the