3/4" - 1" PVC Push Cap Compression Points Connect the hook to the

Connect the hook to the extraction chain

It is threaded into the end of a 2” sch 40 PVC pipe or conduit

1) The compression point is removed in the exit pit

Drop a 2x6x8 board with pre-drilled

QR Code with link to instructional video

3/4" - 1" PVC Push Cap Compression Points Connect the hook to theThe push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed. The push point is connected to the front or leading end of the pipe and the push cap is inserted into the opposite end of the same pipe. Once in place, the push cap may be struck with a hammer to drive the pipe past the obstruction and on to the other side. NOTE: This part is rarely used but in the case of pockets of gravel