Fire hazard testing - Glowing/hot-wire based test methods. Glow-wire flammability test method for end-products (GWEPT) has-tracked-changes contributing to urban cooling through

contributing to urban cooling through evapotranspiration and providing micro-climatic effects that can reduce energy demands in buildings

It is not intended for use by manufacturers or certification bodies

Testing laboratories of chemical disinfectants and antiseptics

IT companies who use data storage devices

See BS EN 15347

Fire hazard testing - Glowing/hot-wire based test methods. Glow-wire flammability test method for end-products (GWEPT) has-tracked-changes contributing to urban cooling through1 Scope This part of IEC 60695 specifies a test method on an end product. It is intended to simulate the effects of thermal stresses produced by an electrically heated source to represent a fire hazard. This test method is used to check that, under defined test conditions, an end product exposed to an electrically heated source has either a limited ability to ignite or, if it ignites, a limited ability to propagate flame. However, the fire hazard