Fibre optic interconnecting devices and passive components. Basic test and measurement procedures - Examinations and measurements. Withdrawal force from a resilient alignment sleeve using gauge pins Ingestion-build-134498 6 Recovery

6 Recovery

BS EN 61189-5-1 provides you with test methods for evaluating printed board assemblies as well as materials used in the manufacture of electronic assemblies

BS EN 13087-4 is the fourth part of the BS EN 13087 series that specifies methods of test for protective helmets

PAS 8850 on non-combusted tobacco products is intended for the following:

Factsheet 12 — Cause and effect diagram

Fibre optic interconnecting devices and passive components. Basic test and measurement procedures - Examinations and measurements. Withdrawal force from a resilient alignment sleeve using gauge pins Ingestion-build-134498 6 Recovery1 Scope This part of IEC 61300 describes the procedure to measure the withdrawal force between the ferrule (gauge pin) of the plug connector and the resilient alignment sleeve of the adapter. The gauge pin should have the same shape (chamfer) like the normal ferrules described in the optical interface, see IEC 617553 series and IEC 61754 series. This measurement procedure is applicable to single fibre cylindrical ferrule optical connectors.