Fan Switch Sub-Harness for K-Swap com or message me on

com or message me on Instagram @Dzrwire

This will delete your need for the factory oem igniter without having to cut or splice into the factory harness

Clips to secure cable while routing through the cabin

Chassis to Inlet Manifold Cable

Harness Features:

Fan Switch Sub-Harness for K-Swap com or message me onLooking to run a Fan Switch on your K Swapped Honda? We have the solution for you! For a clean install, simply plug our harness into your fan switch using the pre wired connector On your connector you have two wires one is a 30cm earth strap to be connected a suitable ground point on your chassis, the other is 200cm in length and covered in a black braided sleeving for a high quality finish in your engine bay, this is ran to your conversion harness